And measure 25 1/2" x 18 1/4" x 10. Internally baffled to minimize sloshing.Includes 3/8" pick-up, 2" neck and hose. This tank allows you to mount the filler neck on either the top or the side. Tank including the flange is the following: 25-1/2" x 18-1/4". Iller neck is 15-1/2" from drivers flange and 6" from the rear of the tank. These dimensions are to the center of the filler neck.
This is the preferred pump for LS based swaps. The assembly has the pressure port, the return port and a vent port. (They are 1/4 npt female). This combo includes one fuel level sending unit. Specify which one you need.
Here are the universal fuel level sending units we have available. TAN-SW (240 ohm empty - 33 ohm full - Normally used with most Autometer, Stewart Warner & Classic gauges). TAN-VDO (10 ohm empty - 180 ohm full - Normally used with most VDO gauges). TAN-GME (0 ohm empty - 30 ohm full - Normally used with most 1964 and older GM gauges).TAN-GML (0 ohm empty - 90 ohm full - Normally used with most 1965 - 1997 GM gauges). There are always exceptions to the above list. Pump and sending unit are not installed.
Check our other auctions for more fuel tanks, steering, frame and suspension parts. This store sells products that may contain chemicals which are known to the State of California to cause cancer, birth defects, or other reproductive harm. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Air & Fuel Delivery\Fuel Tanks & Filler Necks". The seller is "leadmineproducts" and is located in this country: US.
This item can be shipped to United States.